Complete book of fishing hook binding
The fishhook is a common fishing tool, usually tied with the fishing line. There are many ways to bind the fishhook. Here are some common methods to bind the fishhook: 1. Method 1: Wrap the line onto the hook handle, and then slowly wind it around and around, leaving the end of the line and then tighten it.
2. Method 2: Wind the wire into two coils respectively, and then wind one of the coils under the hook handle, and then put the other section of the coil into the upper part of the hook handle, and then tighten it with force, and then wind the remaining wire out of a coil, through which, and finally tighten it
3. Method 3: Wrap a section of thread onto the hook handle, pull one end of the thread towards the head of the hook handle, then wrap another section of thread onto the thread, then tighten it, and then tie the end tightly
4. Method 4: First wind a section of thread under the hook handle, then slowly wind it, thread one end of thread into the loop in the opposite direction, and then thread another section of thread out of the loop, and then tighten it respectively.
5. Method 5: Wrap a section of the line to the head of the hook handle to make the line form a semicircle, and then pull a line head. After threading through it, wrap it out and tighten it one by one
6. Method 6: You need to wind the thread onto the hook handle, wind it for at least one or two turns, and then tie it up and tighten it
7. Method 7: First use a ruler to fix the winding, wrap a section of thread from the lower part of the hook handle, leave the thread end and then go out of the loop, and then put another section of thread end through the loop in the opposite direction, then you can take off the ruler, and finally tighten it with force.
8. Method 8: First slowly wind a section of thread on the head of the hook handle, then select a section of thread to go through the loop, and finally tighten it
9. Method 9: First, slowly wind a section of thread under the hook handle, thread one end of the thread out of the coil, and then thread the other end of the thread out of the coil in the opposite direction, and finally tighten it.
10. Method 10: Wind the wire from the middle of the hook tip to the hook handle, and then tighten it with force after winding, but leave a small coil, put one end of the wire into the coil, and finally tighten it with force.
11. Method 11: Select a small segment of line, tie it to the hook handle, and then wrap the remaining line on the hook handle, and wrap it all around the hook handle.
12. Method 12: Wrap a piece of thread onto the hook handle, then thread the thread end into the winding coil, and then tighten it
13. Method 13: Select a section of thread, start winding from the lower part of the hook handle, leave some thread ends and then tighten it
14. Method 14: Wrap a section of wire on the hook handle, leave a part of the coil temporarily, and finally tighten it slowly
